Schwinn A10 Upright Bike Owner's Manual - Page 14

Console Display Unit operates but Contact HR not displayed HR cable connection at Console HR cable box connection (recumbent only) Sensor grip Dry or calloused hands Console displays "E2" error code Handlebars (recumbent only) Console (upright only) Check data cable integrity Check data cable connections/orientation Console Electronics No speed/RPM reading, Console displays "Pedal" error Check data cable integrity code Check data cable connections/orientation Check magnet position (requires shroud removal) Check RPM Sensor (requires shroud removal) Console shuts off (enters sleep mode) while in use Check data cable integrity Check data cable connections/orientation Reset Machine (if equipped with reset button) If bike has batteries, check Battery Level icon on console or check batteries. Check magnet position (requires shroud removal) Check RPM Sensor If Console only has partial display and all connections are fine, replace the Console. If the above steps do not resolve the problem, contact Customer Care for further assistance. Make sure cable is connected securely to Console. Make sure cables from handlebars and cable to Console are secure and undamaged. Some models may require the seat back be raised to access cable box. Make sure hands are centered on HR sensors. Hands must be kept still with relatively equal pressure applied to each side. Sensors may have difficulty with dried out or calloused hands. A conductive electrode cream such as SIGNACREME® or Buh-Bump™ can help make better conduct. These are available on the web or at medical or some larger fitness stores. If tests reveal no other issues, Handlebars should be replaced. If tests reveal no other issues, Console should be replaced. All wires in cable should be intact. If any are cut or crimped, replace cable. Insure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. If tests reveal no other issues, Console should be replaced. All wires in cable should be intact. If any are cut or crimped, replace cable. Insure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Magnet should be in place on flywheel. If no magnet is present, replace the flywheel or the entire base unit (if unable to replace flywheel). RPM sensor should be aligned with magnet and connected to data cable. Realign sensor if necessary. Replace if there is any damage to the sensor or the connecting wire. All wires in the cable should be intact. If any are cut or crimped, replace cable. Insure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Unplug unit from electrical outlet for 3 minutes. Reconnect to outlet. After the Console powers up, press "reset". If the battery level shows low or no power, replace the batteries. Magnet should be in place on flywheel. If no magnet is present, replace flywheel or entire base unit. Contact Customer Care for further assistance. 14