Schwinn Crewmaster Rowing Machine Assembly and Owners Manual - Page 24

Condition/Problem Console shuts off (enters sleep mode) while in use Unit rocks/does not sit level Rail locking pin does not engage (rail in horizontal position) Seat rolls unevenly Things to Check Check data cable integrity Check data cable connections/orientation Check batteries. Check RPM Sensor Magnet position (requires seat removal) Check RPM Sensor Assembly Check level adjustment Solution All wires in the cable should be intact. If any are cut or crimped, replace cable. Be sure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Make sure batteries are installed correctly. If batteries are correctly installed, replace with a set of new batteries. RPM Sensor Magnet should be in place on Seat slider frame. RPM Sensor Assembly should be aligned with magnet and connected to data cable. Realign sensor if necessary. Replace if there is any damage to the sensor or the connecting wire. Contact Customer Service (if inside US/Canada) or your local distributor (if outside US/Canada). Level adjustment knob may be turned to level machine. Check surface under unit Level adjustment knob Adjustment may not be able to compensate for extremely uneven surfaces. Move machine to level area. Turn the level adjustment knob until the rail locking pin engages the support tube. Seat roller adjustment hardware Turn the adjustment nuts under the seat to adjust the seat rollers. 24