Schwinn IC2 Indoor Cycling Bike Assembly and Owner's Manual - Page 25

Troubleshooting

Page 25 highlights

Troubleshooting Condition/Problem Things to Check Console will not power up/turn Batteries on/start Speed displayed is not accurate Speed displayed is always "0"/ stuck in Pause mode Display set to wrong unit of measure. (English/Metric) Data cable No speed/RPM reading Check data cable integrity Check data cable connections Check magnet position (requires chain guard door removal) Check RPM Sensor (requires chain guard door removal) Console shuts off (enters sleep Check data cable integrity mode) while in use Check data cable connections/orientation Check magnet position (requires chain guard door removal) Check RPM Sensor Solution Make sure batteries are installed correctly. If batteries are correctly installed, replace with a set of new batteries. Change display units. Make sure the data cable is connected to the back of the Console and the main frame assembly. All wires in cable should be intact. If any are cut or crimped, replace cable. Be sure cable is connected securely. Magnet should be in place on sprocket drive. RPM sensor should be aligned with magnet and connected to data cable. Realign sensor if necessary. Replace if there is any damage to the sensor or the connecting wire. All wires in the cable should be intact. If any are cut or crimped, replace cable. Be sure cable is connected securely and oriented properly. Magnet should be in place on sprocket drive. Contact Customer Care for further assistance. 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

25
TROUBLESHOOTING
Condition/Problem
Things to Check
Solution
Console will not power up/turn
on/start
Batteries
Make sure batteries are
installed correctly. If batteries
are correctly installed, replace
with a set of new batteries.
Speed displayed is not
accurate
Display set to wrong unit of
measure. (English/Metric)
Change display units.
Speed displayed is always “0”/
stuck in Pause mode
Data cable
Make sure the data cable is
connected to the back of the
Console and the main frame
assembly.
No speed/RPM reading
Check data cable integrity
All wires in cable should be
intact. If any are cut or crimped,
replace cable.
Check data cable
connections
Be sure cable is connected
securely.
Check magnet position (re-
quires chain guard door
removal)
Magnet should be in place on
sprocket drive.
Check RPM Sensor (requires
chain guard door removal)
RPM sensor should be aligned
with magnet and connected
to data cable. Realign sensor
if necessary. Replace if there is
any damage to the sensor or
the connecting wire.
Console shuts off (enters sleep
mode) while in use
Check data cable integrity
All wires in the cable should be
intact. If any are cut or crimped,
replace cable.
Check data cable
connections/orientation
Be sure cable is connected
securely and oriented properly.
Check magnet position (re-
quires chain guard door
removal)
Magnet should be in place on
sprocket drive.
Check RPM Sensor
Contact Customer Care for
further assistance.