Schwinn Journey 1.0 Upright Bike Assembly and Owner's Manual - Page 8

Attach Stabilizers to Main Frame, Install Console Mast, Mast Gasket and Top Shroud on Main Assembly

Get Schwinn Journey 1.0 Upright Bike PDF manuals and user guides View all Schwinn Journey 1.0 Upright Bike manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

ASSEMBLY 1. Attach Stabilizers to Main Frame Note: H ardware(*) is pre-installed on the stabilizers and not on Hardware Card. Make sure transport wheels on the front stabilizer point forward, and the Schwinn® decal on the rear stabilizer faces outward from the machine. 6 mm X2 * * * 6 mm X2 * * * 2. Install Console Mast, Mast Gasket and Top Shroud on Main Assembly NOTICE: M ake sure the Console Cable connector (a) does not fall into the Console Mast. Align the clips on the cable connectors and make sure the connectors lock. Do not crimp Console Cable. Be sure the tabs on the Top Shroud snap into the Main Assembly. a 6 5 4 X4 CB A 6 mm 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
8
ASSEMBLY
1.
Attach Stabilizers to Main Frame
Note:
Hardware(*) is pre-installed on the stabilizers and not on Hardware Card. Make sure transport wheels on the
front stabilizer point forward, and the Schwinn
®
decal on the rear stabilizer faces outward from the machine.
2.
Install Console Mast, Mast Gasket and Top Shroud on Main Assembly
NOTICE:
Make sure the Console Cable connector (a) does not fall into the Console Mast. Align the clips on the cable
connectors and make sure the connectors lock. Do not crimp Console Cable. Be sure the tabs on the Top
Shroud snap into the Main Assembly.
X2
X2
6 mm
6 mm
*
*
*
*
*
*
6
5
4
A
6 mm
C
B
X4
a