Seagate ST300MM0026 Savvio 10K.2 SAS Product Manual - Page 61
Differential signals, 5.2.1, Eye masks, Table 25, LED drive signal, Table 26, General interface
View all Seagate ST300MM0026 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Table 24: Ready LED Out conditions Normal command activity Format in progress, each cylinder change LED status Toggles on/off The Ready LED Out signal is designed to pull down the cathode of an LED. The anode is attached to the proper +3.3 volt supply through an appropriate current limiting resistor. The LED and the current limiting resistor are external to the drive. See Table 25 for the output characteristics of the LED drive signals. Table 25: LED drive signal State LED off, high LED on, low Test condition 0 V ≤ VOH ≤ 3.6 V IOL = 15 mA Output voltage -100 μA < IOH < 100 μA 0 ≤ VOL ≤ 0.225 V 10.5.2 Differential signals The drive SAS differential signals comply with the intra-enclosure (internal connector) requirements of the SAS standard. Table 26 defines the general interface characteristics. Table 26: General interface characteristics Characteristic Bit rate (nominal) Unit interval (UI)(nominal) Impedance (nominal, differential ) Transmitter transients, maximum Receiver transients, maximum Units Mbaud ps ohm V V 1.5 Gbps 1,500 666.6 100 ± 1.2 ± 1.2 3.0 Gbps 3,000 333.3 100 ± 1.2 ± 1.2 10.5.2.1 Eye masks 10.5.2.1.1 Eye masks overview The eye masks are graphical representations of the voltage and time limits on the signal at the compliance point. The time values between X1 and (1 - X1) cover all but 10-12 of the jitter population. The random content of the total jitter population has a range of ± 7 standard deviations. Savvio 10K.2 SAS Product Manual, Rev. E 55