Seagate ST3300657SS Cheetah 15K.7 FC Product Manual - Page 77
LED driver signals, FC Differential output, FC Differential input
UPC - 715663214328
View all Seagate ST3300657SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
10.6.2 LED driver signals Fault and Active LED signals are located in the FC-SCA connector (J1). See Table 30 for the output characteristics of the LED drive signals. Table 30: LED drive signal State LED off, high LED on, low Current drive available 0 < IOH < 100µA IOL < -30 mA Output voltage 0 < VOL < 0.8V 10.6.3 FC Differential output The serial output signal voltage characteristics are provided in Table 31. The outputs are not AC coupled in order to deliver maximum signal without rise and fall time degradation. You must AC couple the receiver to isolate potentially different DC characteristics of the outputs and the receiver. Table 31: FC Differential output characteristics Description Serial output voltage swing Parameter 600 < Vout < 1300 mV Notes Centered at 1.32V Figure 15 provides the data output valid eye diagram relative to the bit cell time. Bit Time Vout (mv) XMIT Eye Figure 15. Transmit eye diagram 10.6.4 FC Differential input The serial input signal voltage characteristics are provided in Table 32. Table 32: FC Differential input characteristics Description Serial input voltage swing Parameter 200 < Vin < 1.300 mV Notes AC coupled Cheetah 15K.7 FC Product Manual, Rev. B 71