Seagate ST3600002FC Cheetah NS 10K.2 FC Product Manual - Page 78
LED driver signals, FC Differential output, FC Differential input
View all Seagate ST3600002FC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
9.6.2 LED driver signals Fault and Active LED signals are located in the FC-SCA connector (J1). See Table 29 for the output characteristics of the LED drive signals. Table 29: LED drive signal State LED off, high LED on, low Current drive available 0 < IOH < 100µA IOL < -30 mA Output voltage 0 < VOL < 0.8V 9.6.3 FC Differential output The serial output signal voltage characteristics are provided in Table 30. The outputs are not AC coupled in order to deliver maximum signal without rise and fall time degradation. You must AC couple the receiver to isolate potentially different DC characteristics of the outputs and the receiver. Table 30: FC Differential output characteristics Description Serial output voltage swing Parameter 600 < Vout < 1300 mV Notes Centered at 1.32V Figure 15 provides the data output valid eye diagram relative to the bit cell time. Bit Time Vout (mv) XMIT Eye Figure 15. Transmit eye diagram 9.6.4 FC Differential input The serial input signal voltage characteristics are provided in Table 31. Table 31: FC Differential input characteristics Description Serial input voltage swing Parameter 200 < Vin < 1.300 mV Notes AC coupled 72 Cheetah NS 10K.2 FC Product Manual, Rev. B