Sealey CP1205 Instruction Manual - Page 1

12V Ø71MM CORDLESS POLISHER - BODY ONLY MODEL NO: CP1205 Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE. Refer to Wear protective instruction gloves manual 1. SAFETY Wear eye protection Wear face mask 9 Disconnect the polisher from the battery unit before changing accessories, servicing or performing any maintenance. 9 Maintain the polisher and battery in good condition. Check moving parts alignment on a regular basis. 9 Replace or repair damaged parts. Use an authorised service agent and recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty. 9 Ensure the polisher is switched off before installing the battery pack. 9 Keep the polisher and charger clean for best and safest performance. 9 Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and contain long hair. 9 Evaluate your working area before using the polisher e.g. ceilings, floors and enclosures may contain electrical items or water piping. 9 Ensure battery pack is correctly inserted into the polisher handle and latched in place before attempting to switch on polisher. 9 Secure loose work pieces with a clamp, vice or other adequate holding device. 9 Avoid unintentional starting. 9 Wear approved safety eye protection (standard spectacles are not adequate). 9 Maintain correct balance and footing. Ensure the floor is not slippery and wear non-skid shoes. 9 Keep children and unauthorised persons away from the working area. 9 Store polisher and charger in a safe, dry, childproof area where the temperature will not exceed 104°F (40°C). 8 DO NOT use the polisher where there are flammable liquids, solids or gases, such as paint solvents, etc. 8 DO NOT allow children to operate the polisher. 8 DO NOT operate the polisher if any parts are missing as this may cause failure and/or personal injury. 8 DO NOT hold unsecured work piece in your hand. 8 DO NOT leave the polisher operating unattended. 8 DO NOT carry the polisher with your finger on the power switch. 8 DO NOT use the polisher for a task it is not designed to perform. 8 DO NOT operate the polisher when you are tired or under the influence of alcohol, drugs or intoxicating medication. 8 DO NOT get the polisher or battery wet or use in damp or wet locations. 2. INTRODUCTION Compact, lightweight cordless polisher. Comfortable composite housing with soft grip to reduce vibration. Two speed settings and variable speed control trigger make this polisher easy to use. Integral LED battery level indicator. Supplied with side handle for greater control of use. 3. i SPECIFICATION Model No CP1205 Battery options 12V 1.5Ah Li-ion, 12V 3Ah Li-ion, 12V 4Ah Li-ion (not included) Consumable parts CP1200BP - Battery 12V 1.5Ah, CP1200BP3 - Battery 12V 3Ah, CP1200BP4 - Battery 12V 4Ah (not included) Free speed 0-2500rpm/0-7500rpm Noise power/pressure 90/79dB(A) Vibration/uncertainty 4.213/1.5m/s² Pad size 71mm Replacement parts CP1200MC - Mains charger Thread size 5/16"UNF © Jack Sealey Limited Original Language Version