Sennheiser SL DW Handheld Instruction manual SpeechLine Digital Wireless PDF - Page 55

Multi-room mode When you are using multiple SL Multi-Channel Receiver DW units, it is possible to daisy-chain the network and audio signals by using the "Single-Cable Mode" (factory default setting, see „Connecting the receiver"). PoE will not be daisy-chained, so a PoE injector is required for any additional SL Multi-Channel Receiver DW. Multi-Room Mode setup with SL Rack Receiver DW only When installing SpeechLine Digital Wireless in several rooms, it is crucial that you perform the following steps one after the other and room by room. When installing SpeechLine Digital Wireless devices in one room, all devices in all other rooms must be switched off. ▷ Install all receivers in a room in one rack (see „Installing receivers in a rack"). ▷ Connect all cables for the receivers (see „Connecting the receiver"). ▷ Make sure to power all receivers via a multiple socket with a central power switch. ▷ Mount all antennas as recommended and feasible (see „Recommendations on antenna mounting"). ▷ Ensure that all receivers are switched off. ▷ Switch on the first receiver. This receiver will become the Master. ▷ If necessary, pair a transmitter. Only if necessary, as the sets are delivered already paired. ▷ Set the RF power of the receiver to the recommended RF power level according to the room size as indicated on the receiver UI or in the Sennheiser Control Cockpit. ▷ Power cycle (switch off and on again) the receiver to verify the selected value. 54