Sharp AF-P80CX AF-P80CX Operation Manual - Page 13

HOW TO OPERATE ENERGY SAVER During normal operation, the thermostat automatically controls cooling and the fan runs continuously. When the ENERGY SAVER is selected, the thermostat automatically controls cooling and the fan automatically stops when the compressor is not operating. (Fan will stop 30 seconds after the compressor stops. After the fan stops, the fan is programmed to rotate for approx. 2 minutes to detect room temperature. This will occur within a 20 min time span.) F hr COOL / FAN TEMP SELECTOR TIMER ENERGY ON/OFF SAVER POWER ON/OFF ENERGY SAVER pad ENERGY SAVER indicator During cooling operation 1 Touch ENERGY SAVER pad. • ENERGY SAVER indicator will light. 2 To cancel, touch ENERGY SAVER pad again. • ENERGY SAVER indicator will go off. NOTE: ENERGY SAVER cannot be set during fan only (HIGH FAN, MED FAN, LOW FAN) operation. TO CHANGE AIR FLOW DIRECTION The horizontal louvers are used to adjust the UP / DOWN direction of air flow, and the vertical louvers are used to adjust the LEFT / RIGHT direction of air flow for uniform and efficient cooling of the room. Horizontal louvers Vertical louvers Adjust UP/DOWN air flow Lever Adjust LEFT/RIGHT air flow 13