Sharp AF-P80CX AF-P80CX Operation Manual - Page 16

HOW TO OPERATE USING THE REMOTE CONTROL INSTALLING BATTERIES Use two AA (R6) batteries. 1 Remove the battery compartment cover. 2 Insert the batteries in the compartment, making sure the and polarities are properly aligned. 3 Replace the cover. Battery compartment cover NOTES: • The battery life is approximately one year with normal use. • When you replace the batteries, always use two new ones of the same type. • If the remote control does not operate normally after replacing the batteries, take out the batteries and replace them again after 30 seconds. • If you will not be using the unit for a long time, remove the batteries from the remote control. HOW TO USE THE REMOTE CONTROL Point the remote control towards the unit's receiver window and press the desired button. A beep will sound when the unit receives the signal. • Make sure no objects, such as curtains, block the receiver window. • The remote control operates from up to 20 feet (6 meters) away. • The beep will also sound when each pad on the control panel is touched. CAUTION: • Do not expose the receiver window to direct sunlight. This can adversely affect its operation. In such case, close the curtains to block the sunlight. • Use of a fluorescent lamp in the same room may interfere with the transmission of the signal. • The unit may be affected by signals emitted from the remote control of a television, VCR or other equipment used in the same room. • Do not leave the remote control exposed to direct sunlight or near a heater. Protect the remote control from moisture and shock which can discolor or damage it. 16