Sharp AL-1340 AL-1340 Operation Manual - Page 33
Copier Trouble? - troubleshooting
UPC - 074000074347
View all Sharp AL-1340 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
6 COPIER TROUBLE? This chapter describes misfeed removal and troubleshooting. MISFEED REMOVAL When the misfeed ( ) indicator blinks or of a misfeed. blinks in the display, the copier will stop because 1 Open the side cover while pressing the side cover open button. 2 Check the misfeed location. Remove the misfed paper following the instructions for each location in the illustration below. If blinks in the display, proceed to "A Misfeed in the paper feed area". (p. 31) 6 If paper is misfed here, proceed to "B Misfeed in the fusing area". (p. 32) Copier trouble? If the misfed paper is seen from this side, proceed to "C Misfeed in the transport area". (p. 33) If paper is misfed here, proceed to "A Misfeed in the paper feed area". (p. 31) A Misfeed in the paper feed area 1 Gently remove the misfed paper from the paper feed area as shown in the illustration. When blinks in the display and the misfed paper is not seen from the paper feed area, pull out the paper tray and remove the misfed paper. If the paper cannot be removed, proceed to "B Misfeed in the fusing area". The fusing unit is hot. Do not touch the fusing unit when removing misfed paper. Doing so may cause a burn or other injury. G Do not touch the surface of the drum (green portion) of the drum cartridge when removing the misfed paper. Doing so may damage the drum and cause smudges on copies. G If the paper has been fed through the manual bypass, do not remove the misfed paper through the manual bypass. Toner on the paper may stain the paper transport area, resulting in smudges on copies. 31