Sharp AR-153E AR-153E AR-157E Operation Manual Suite - Page 17
Using the RSPF/SPF, of originals. - user guide
View all Sharp AR-153E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Using the RSPF/SPF The RSPF/SPF is designed to hold up to 30 originals measuring from 5-1/2" x 8-1/2" to 8-1/2" x 14" and weighting from 14 lbs. to 23.9 lbs. • Before feeding originals in the original feeder tray, be sure to remove any staples or paper clips from them. • Before placing curled or wavy originals into the original feeder tray, be sure to flatten them. If not, original misfeeds may result. • The RSPF/SPF ( ) indicator on the operation panel will light up. If this indicator does not light up, the originals are not properly set or the RSPF/SPF is not properly closed. • Badly damaged originals may misfeed in the RSPF/SPF. It is recommended that such originals be copied from the original table. • Special originals such as transparency film should not be fed through the RSPF/SPF, but should be placed directly on the original table. 3 • Image loss (max. 5/32") can occur at the leading and trailing edges of the copies. Also image loss (max. 11/64" in total) can occur along the other edges of the copies. It can be 15/64" (max.) at the trailing edge of the second copy of two-sided copying. • To stop continuous copying using the RSPF/SPF, press the clear ( ) key. • Copying using one-sided to one-sided mode (AR-157E): Ensure that no indicator is lit among the original to copy indicators. 1 Make sure that no original is left on the original table. 2 Adjust the original guides to the size of originals. 3 Set the originals face up in the original feeder tray. Original face up Stream feeding mode The stream feeding mode allows easy operation of continuous copying from the RSPF/SPF. If the stream feeding mode has been enabled using user program No.4, the RSPF/SPF ( ) indicator will blink approximately 5 seconds after the last original has been fed by the RSPF/SPF. While this indicator is blinking, any new originals placed in the original feeder tray will be fed and copied automatically. If the stream feeding mode has been disabled, the start ( ) key must be pressed each time the originals are set even immediately after completion of a copy run from the RSPF/SPF. The default setting of the stream feeding mode is "ON". See "USER PROGRAMS" (p.23). 15