Sharp AR-M450 AR-M280 AR-M350 AR-M450 Operation Manual (for multifunction - Page 94
Troubleshooting concerning the saddle stitch finisher
View all Sharp AR-M450 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
SADDLE STITCH FINISHER Troubleshooting (concerning the saddle stitch finisher) Check the list below before contacting the SHARP Service Center. Problem Stapling position is not correct (including saddle stitch). The saddle stitch finisher does not operate. Stapling cannot be performed (including saddle stitch). Punch position is not proper.*1 Cannot be punched.*1 Not properly arranged if the saddle stitch function is used in the copy mode. GStapling position not set properly in the stapling setting? GThe top cover or the front cover of the saddle stitch finisher open? GMessage indicating need to remove paper from the stapler compiler displayed? GMessage requesting check for the staple unit displayed? GMessage requesting adding staples displayed? GDifferent size paper included? GPaper heavily curled? GPunch function set properly in accordance with the punch position? GMessage requesting check for punch module displayed? GDifferent size paper included? GPaper heavily curled? GPamphlet copy set? Solution Check the stapling position setting. (See page xx.) Close all covers. (See pages xx and xx.) Remove all remaining paper from the stapler compiler referring to step 3 on page xx. Remove jammed staples. (See page xx.) Replace the staple cartridge. (See page xx.) Stapling cannot be performed onto different size paper. Paper may be curled heavily depending on the paper type and quality. Remove paper from the paper tray or the bypass tray, turn it upside down, and load it again. Check the punch position and set it again. (See page xxxx.) Dispose of punch scraps. (See page xxxx.) Punching cannot be performed onto different size paper. Paper may be curled heavily depending on the paper type and quality. Remove paper from the paper tray or the bypass tray, turn it upside down, and load it again. Set the pamphlet copy function and then perform saddle stitch. *1 When a punch unit is installed as a peripheral unit 5-26