Sharp AS271F pdf - Page 19

To connect the monitor to your system, follow these instructionsG, ²OTEG, CAUTIO²G

Get Sharp AS271F PDF manuals and user guides View all Sharp AS271F manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

To connect the monitor to your system, follow these instructions:  NOTE: Make sure to read "Recommended Use" on page 3 before installation. 1. Turn off the power to your computer. 2. Place the monitor face down on a non-abrasive surface. 3. Connect devices to the monitor. English DisplayPort Audio IN HDMI D-SUB Headphone Power cord  CAUTION: Use the provided specified cables with this product so as not to interfere with radio and television reception. For mini D-Sub 15-pin, please use a shielded signal cable with core. For HDMI and DisplayPort, please use a shielded signal cable. Use of other cables and adapters may cause interference with radio and television reception.  CAUTION: • Do not connect headphones to the monitor while you are wearing them. Depending on the volume level, it may damage your ears and cause loss of hearing.  NOTE: • Adjustment of the volume control as well as the equalizer to other settings than the center position may increase the ear-/headphones output voltage and therefore the sound pressure level.  • Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor lowers the sound.  • Incorrect cable connections may result in irregular operation, damage display quality/components of the LCD module and/or shorten the module's life. 4. Connect the power cord to a power outlet.  NOTE: • Please refer to the Caution section of this manual for proper selection of the AC power cord (see page 1).  • Please make sure that enough power is supplied to the monitor. Please refer to "Power Supply" in the "Chapter 4 Specifications" on page 26. 5. Turn on the monitor by pressing the button and then turn on the computer.  NOTE: If you have any problems please refer to the Troubleshooting section of this User's Manual (see page 23). English−17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
English−17
English
To connect the monitor to your system, follow these instructionsG
²OTEG
Make sure to read
“Recommended Use” on page 3
before installation.
1. Turn off the power to your computer.
2.
Place the monitor face down on a non-abrasive surface.
3. Connect devices to the monitor.
HDMI
Power cord
DisplayPort
D-SUB
Headphone
Audio IN
CAUTIO²G
Use the provided specified cables with this product so as not to interfere with radio and television reception.
For mini D-Sub 15-pin, please use a shielded signal cable with core.
For HDMI and DisplayPort, please use a shielded signal cable.
Use of other cables and adapters may cause interference with radio and television reception.
CAUTIO²G
• Do not connect headphones to the monitor while you are wearing them. Depending
on the volume level, it may damage your ears and cause loss of hearing.
²OTEG
• Adjustment of the volume control as well as the equalizer to other settings than the center position may increase
the ear-/headphones output voltage and therefore the sound pressure level.
°
Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor lowers the sound.
°
Incorrect cable connections may result in irregular operation, damage display quality/components of the LCD
module and/or shorten the module’s life.
4. Connect the power cord to a power outlet.
²OTEG
• Please refer to the Caution section of this manual for proper selection of the AC power cord (see
page 1
).
°
Please make sure that enough power is supplied to the monitor. Please refer to
“Power Supply”
in the
“Chapter 4 Specifications” on page 26
.
5. Turn on the monitor by pressing the
button and then turn on the computer.
²OTEG
If you have any problems please refer to the Troubleshooting section of this User’s Manual (see
page 23
).