Sharp AS271F pdf - Page 26

Screen Image and Video Signal Issues No picture • Make sure the signal cable is fully connected to the monitor and the computer. • Make sure there is no DisplayPort converter adapter connected. The monitor does not support DisplayPort converter adapter. • Make sure the computer's display card is completely seated in its slot. • Make sure both the computer and monitor are powered on. • Make sure that a supported resolution has been selected on the display card or system being used. If in doubt, please refer to the user's manual of the display controller or system to change the resolution. • Check the monitor and your display card with respect to compatibility and recommended signal timings. • Check the signal cable connector for bent or pushed-in pins. • The monitor may be in power saving mode. The monitor automatically goes into standby at the preset time period after the video signal is lost. The image is unstable, unfocused or swimming is apparent • Make sure the signal cable is fully connected to the monitor and the computer. • Use the OSD Image Adjust controls to focus and adjust the display by increasing or decreasing the [PHASE] adjustment. When the display mode is changed, the OSD Image Adjust settings may need to be readjusted. • Check the monitor and your display card with respect to compatibility and recommended signal timings. • Disconnect the DisplayPort cable and press the [ENTER] button while "NO SIGNAL" is displayed. When the [DP LONG CABLE] is displayed, adjust the OSD value using [DOWN] button and [UP] button and press [ENTER] button and [EXIT] button. Connect the DisplayPort cable and make sure the picture image. The image is not properly reproduced • Use the OSD Image Adjust controls ([H POSITION], [V POSITION], [CLOCK], and [PHASE]). (Analog input only). • Use the [AUTO ADJUST] functions. (Analog input only). Picture is not bright • Make sure [ECO MODE] is [OFF]. • Make sure the signal cable is fully connected to the monitor and the computer. • LCD brightness degradation occurs due to long-term usage or extreme cold conditions. • If the brightness fluctuates, make sure [DV MODE] is set to [OFF]. Selected resolution is not displayed properly • If the resolution you set is over or under a range, "OUT OF RANGE" window will appear then warn you. Please set supported resolution at the connected computer. Brightness variations over time • Change [DV MODE] to [OFF] and adjust brightness.

NOTE: When [DV MODE] is set to [ON], the monitor automatically adjusts brightness based on the video signal. No Video • If no video is present on the screen, turn the button off and on again. • Make sure the computer is not in a power-saving mode by touching the connected keyboard or the connected mouse. English−24