Sharp CD-G10000 CD-G10000 Operation Manual - Page 35

Sequential recording from several discs: 1 Perform steps 1 - 5 in "Recording from a CD or MP3 disc" on page 34. 2 Within 5 seconds, press the / button. To perform programmed recording: 1 Program discs and tracks (see pages 25, 29). 2 Press the button. 3 Press the / button. To stop recording: Press the button. The disc and tape will stop. „ Recording from the radio 1 Tune in to the desired station (see page 30). 2 Load a cassette into the TAPE 2 cassette compartment with the side to be recorded on facing you. Wind past the leader of the tape, on which recording cannot be performed. 3 Press the button. Recording will be paused. 4 Press the / button to start recording. To interrupt recording: Press the button. To resume recording, press the / button. To stop recording: Press the button. Note: If you hear a whistling noise while recording an AM station, move the AM loop antenna. „ Dubbing from tape to tape You can record from TAPE 1 to TAPE 2. 1 Press the ON/STAND-BY button to turn the power on. 2 Load a prerecorded cassette into the TAPE 1 cassette compartment. Insert a blank tape into the TAPE 2 cassette compartment. TAPE 1 TAPE 2 CD-G10000 CP-G10000S Tape Recording It is recommended that the recording tape is the same length as the master tape. 3 Press the TAPE (1 2) button until "TAPE 1" appears on the display. 4 Press the button. Recording will be paused. 5 Press the / button to start dubbing. To stop dubbing: Press the button. TAPE 1 and TAPE 2 will simultaneously stop. „ Erasing recorded tapes 1 Load the tape to be erased into the TAPE 2 cassette compartment with the side to be erased facing toward you. 2 Press the TAPE (1 2) button until "TAPE 2" appears on the display. 3 Press the button. 4 Press the / button to start erasing. Note: Make sure that the TAPE 1 is not in use. 35