Sharp CV-2P10SC CV-2P10SC Operation Manual - Page 14
guard net. - install
View all Sharp CV-2P10SC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
INSTALL WINDOW PANEL Installation in a sliding sash window 1 Connect the rain guards to the insect guard net. Insert all three projections on each rain guard into the holes in the insect guard net. Side "A" will now be at the top, as indicated in the diagram. 2 Attach the guard combined above to the window panel. Push the insect guard net firmly to ensure that its four projections fit into the holes in the window panel. Side "A" will now be at the top, as indicated in the diagram, when it is installed in the window. Insect guard net Hole Projection Projection 3 Cut the foam seal A (adhesive type) to the proper length and attach it to the window frame. "A" Rain guard Window panel "A" Foam seal A 4 Install the window panel into the window frame. Make sure that the exhaust cover is attached to the window panel. Inner height of the window: 21.3" (540mm) - 28.3" (718mm) Use the window panel. The window panel cannot be installed in windows less than 21.3" (540mm) high, as you will be unable to shut the exhaust cover. (1) Cut the window panel to the same height as the window. (2) Open the window sash and place the window panel on the window frame. (3) Secure the window panel to the window frame with 2 screws. Exhaust cover Window panel Cut 21.3"-28.3" EN-12 CV-2P10SC_en.indd 12 11.3.22 11:00:14 AM