Sharp CV-2P10SX Operation Manual - Page 12
Install Window Panel
View all Sharp CV-2P10SX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
INSTALL WINDOW PANEL Installation in a double-hung sash window 1 Connect the rain guards to the insect guard net. Insect guard net Hole Insert all three projections on each rain guard into the holes in the insect guard net. Side "A" will now be at the top, as indicated in the diagram. Projection Rain guard "A" 2 Attach the guard combined above to the window panel. Projection Push the insect guard net firmly to ensure "A" that its four projections fit into the holes in the window panel. Side "A" will now be at the top, as indicated in the diagram. Window panel 3 Cut the foam seal A to the proper length and attach it to the window stool. Foam seal A 4 Attach the window panel to the window stool. Make sure that the exhaust cover is attached to the window panel. Inner width of the window 21.3"(540mm) - 28.3"(718mm) Use the window panel. The window panel cannot be installed in windows less than 21.3" (540mm) wide, as you will be unable to shut the exhaust cover. (1) Cut the window panel to the same width as the window. (2) Open the window sash and place the window panel on the window sill. (3) Secure the window panel to the window stool with 2 screws. Exhaust cover Window panel Cut EN-10 21.3" - 28.3" CV-2P13SX_en.indd 10 11.3.3 5:58:16 PM