Sharp FP-NC25CX FP-N25CX Operation Manual - Page 15

OPERATION ENGLISH PLASMACLUSTER INDICATOR LIGHT Plasmacluster ion operation is selected using the remote control. Blue light When the Plasmacluster ion operation is in Clean Mode, or in AUTO Plasmacluster Ion Mode and the air in the room is impure, the light will activate and the unit will operate in Clean Mode. Green light When the Plasmacluster ion operation is in the Ion Control Mode, or in AUTO Plasmacluster Ion Mode and the air in the room is clean, this light will activate and the unit will operate in Ion Control Mode. Light off There are no Plasmacluster ions being generated. CLEAN-SIGN LIGHT The color changes according to the air condition. Clean (Green) Slightly Impure (Orange) Very Impure (Red) ABOUT THE CLEAN-SIGN • The condition of the CLEAN-SIGN depends on the Odor Sensor's reading of the room environment when the plug is inserted into the wall outlet. • It is possible to have a green CLEAN-SIGN with impurities in the air if the air purifier was just introduced to the room environment. After a while, however, the base impurity rate will be adjusted to read room environment correctly. REMOTE CONTROL USE • Operate with the remote control facing the main unit receiver. • The signal range is about 23 feet (7m). • Make sure there are no objects blocking the path of the signal. • A beep sound will be heard from the main unit when a signal is received. NOTE • Avoid dropping or damaging the remote control, using in a high humidity condition, in direct sunlight or near a heat source. E-13 Receiver Transmitter