Sharp FP-NC25CX FP-N25CX Operation Manual - Page 16

OPERATION REMOTE CONTROL OPERATION • When you press the POWER ON/OFF Button, a short beep will sound and operation will start in AUTO Mode. Operations available with the Remote Control • AUTO • MANUAL • POLLEN • OFF TIMER • QUICK AUTO Plasmacluster Ion mode selections • AUTO • CLEAN • ION CONTROL • OFF POWER ON/OFF Button To stop, press the POWER ON/OFF Button again. A long beep will sound and operation will stop. Auto (Fan Speed) Button The fan speed switches automatically depending on the amount of impurities in the air. Manual (Fan Speed) Button The fan speed can be switched among Silent, Low, and High settings. Quick Auto Button The operation mode is effective when quick removal of impurities in the air is desired. POWER ON/OFF Fan Control OFF AUTO MANUAL POLLEN TIMER QUICK AUTO Plasmacluster CLEAN AUTO OFF ION CONTROL Transmitter Pollen Mode Operation Button See Page E-12 Off Timer Button The set time switches every time the button is pressed as shown below. 1 hour 4 hours Cancel 8 hours • The indicator light shows the remaining time. Note: By manually selecting either Ion Control or Clean Mode, this will lock the unit into the selected mode and will not change to the other even if room condition changes. Plasmacluster Ion mode Selections Auto When pressed, the unit will switch between Clean Mode and the Ion Control Mode automatically depending on the amount of impurities in the air as detected by the odor sensor. Clean Mode will operate for 1 minute when the Auto function is selected. Clean When pressed, the unit will constantly operate in the Clean Mode, in which the same numbers of positive and negative ions are discharged. The Plasmacluster Indicator Light is blue. Ion Control When pressed, the unit will constantly operate in Ion Control Mode. The Plasmacluster Ion Indicator Light is green. Off The generation of ions will cease and the Plasmacluster Indicator Light will go out. E-14