Sharp IG-A10UR IG-A10UR IG-A10UW Operation Manual - Page 14

SPECIFICATIONS Model Power supply Power consumption (W) Airflow volume CFM Applicable floor surface area * Power cord Outer dimensions (in.) Weight IG-A10U 120V, 60Hz (High) 14.0 (Low) 5.8 (High) 60(1.7m3/min) (Low) 42(1.2m3/min) 108sq ft (10m2) 5.9 ft (1.8m) 5 1/2 x 6 1/4 x 13 1/2 (W x D x H) 5.5lbs(2.5kg) *The target floor surface area for which an emitted airborne ion density of about 25,000 ions/cm3 can be measured at a point near the center of the room (at a height of about 1.2 m from the floor), during operation at the HIGH mode when the main unit is placed near a wall. • The number of ions will vary according to the room conditions and the main unit operation mode. TROUBLESHOOTING Before calling for service, please review the TROUBLESHOOTING chart below,since the problem may not be Plasmacluster Ion Generator malfunctions. Problem WHAT TO DO The Plasmacluster Ion Generator Make sure plug is completely plugged into the does not work. wall and that outlet is functioning properly. flashing faster (red) Approx. 2 years and 2 months (approx. 19,000 hours) has been passed. Replace with a new Plasmacluster Ion Generating Unit. See page E-11,12. flashing (blue) flashing (red) Plasmacluster Ions are not released. Press the Operation button and restart. Clean the electrode section the unit. See page E-9. Dust may block the filter, clean the filter. flashing (blue) flashing (blue) Please unplug the Plasmacluster Ion Generating Unit once. If still does not improve, please contact the Sharp Service Center. The discharged air has odor. The Plasmacluster Ion Generator releases a small trace of ozone which may produce odor. This is not harmful to health. A clicking or ticking sound comes from the unit while operating the Plasmacluster Ion Generator. Loudness can be changed depending on room humidity, but the effectiveness is the same. Relocate the Plasmacluster Ion Generator if necessary. E-12