Sharp KB-0333KK KB-0333K Operation Manual / Installation Instructions - Page 6

PREPARE THE HOOD 1 Remove 7" Round Duct Plate from top of hood. Set duct plate aside - with mounting screws. 2 Remove tape holding Filters in place. Pull down on filter tabs or finger holes and lift filters out. Set filters aside. 3 Remove Teflon®Coated Bottom Cover from hood. Set cover and mounting screws aside. Teflon® is a registered trademark of DuPont. 4 Remove Damper/ Duct Connector from inside the hood. Set connector aside - with mounting screws and parts bag. TEFLON®-COATED BOTTOM COVER (Held in place with 2 screws) 5 Remove either top or back wiring knockout and install approved Electrical Cable Clamp. DAMPER/ DUCT CONNECTOR ELECTRICAL CABLE CLAMP NON-DUCTED INSTALLATION - Skip to page 8. The following Steps (6 thru 14) are for DUCTED INSTALLATION ONLY. 6 Remove Light Panel - held in place with (5) #8 screws. Disconnect light assembly wire harness (white connector). 7 Remove Air Chute - held in place with one (1) screw. Note: Be careful not to disconnect any wires. 8 Remove Baffle from air chute. 9 Rotate baffle. Reinsert baffle into air chute (as shown) so that baffle Tabs fit all the way into Slots in air chute. An audible "click" will be heard when fully installed. This will close off the air flow through the non-ducted slots on top of hood. 6