Sharp KB-6014LW Installation Manual - Page 2

CLEARANCES AND DIMENSIONS • Dimensions that are shown in Figure 1 (for 24") or Figures 3 and 4 (for 30") must be used. Given dimensions provide minimum clearance. Locate electrical outlet in the shaded area in the upper left-hand corner of the cutout. See Figure 7. • Contact surface must be solid and level. Pay special attention to the floor on which the Microwave Drawer will sit. The floor of the opening should be constructed of plywood strong enough to support the weight of the oven (about 100 pounds). • Check location where the Microwave Drawer will be installed for proper electrical supply. • Your oven can be built into a cabinet or wall by itself or under a gas or electric wall oven. • Be sure that the clearance of the floor between the wall oven and the microwave drawer is a minimum of 2-inches. • The microwave interior will easily accommodate a 9" x 13" oblong dish or a bag of microwave popcorn. 24" MICROWAVE DRAWER MEASUREMENTS Electrical outlet location 5" (6") Anti-Tip block 3 1/2" 36" countertop height 4" 22 1/8" opening Allow 7/8" overlap. 23 1/2" min depth Allow 7/8" overlap. Allow 3/16" overlap. 14 13/16" opening 14 13/16" to bottom of Anti-Tip block Allow 7/16" overlap. Floor must support 100 lbs. 19" to top of floor Figure 1 24" cabinet min. Figures 1 and 2 contain many Microwave Drawer measurements for reference when planning the drawer's location. 4 11/16" 1 23/32" 21 19/32" 15 13/32" Figure 2 23 7/8" 15" auto drawer opening 14 19/32" 23 3/8" 1 13/16" door thickness 2