Sharp LC-46D62U LC-46D62U LC-52D62U Operation Manual - Page 7

Supplied accessories Make sure the following accessories are provided with the product. Remote control unit "AAA" size battery (g1) (g2) Page 8 Page 8 AC cord (g1) Page 7 Cable Clamp (g2) Cable tie (g1) Page 7 Stand unit (g1) Page 6 Operation manual (g1) NOTE • Always use the AC cord supplied with the TV. • AC cord enclosed in this product is for 110-125V. In using it on the 125-240V AC, please consult to the following. SHARP ELECTRONICS CORPORATION 6100 Blue Lagoon Drive, Suite 230, Miami, Florida 33126, U.S.A. QUICK REFERENCE Attaching the stand • Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal. • Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged. CAUTION • Attach the stand in the correct direction. • Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over. 1 Confirm that there are 10 screws (6 short screws and 4 long screws) supplied with the TV. 3 1 Insert the stand into the openings on the bottom of the TV. 2 Insert and tighten the 4 long screws into the 4 holes on the rear of the TV. 2 Attach the two supporting posts for the stand unit onto the base using the box for the stand unit as shown below. (Close-up of the upper side of the stand unit) Hex key 2 Long screw 2 Soft cushion 32 1 23 1 Hex key Short screw 1 Insert each of the protrusions on the two supporting posts into the openings on the upper side of the base. 2 Insert and tighten the 6 short screws with the hex key (supplied with the product) in the order of 1, 6 2 and 3. 1 NOTE • To detach the stand, perform the steps in reverse order.