Sharp LC-90LE657U Operation Manual - Page 9
Attaching the Stand (for the 90/80 Inch Models), Building the Work Table - installation manual
View all Sharp LC-90LE657U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
QUICK REFERENCE ■ LC-70LE657U/LC-60LE657U/LC-70LE655U/ LC-60LE655U/LC-70LE650U/LC-60LE650U/ LC-70C6500U/LC-60C6500U 1 Confirm that there are 12 screws (8 long screws and 4 short screws) supplied with the stand unit. 2 1 Set the post for the stand unit onto the polystyrene foam. 2 Attach the base to the post. 3 Insert and tighten the 8 screws into the 8 holes on the bottom of the base. • Hold the stand unit securely with one hand, and then tighten the screws. ■ LC-70LE657U/LC-70LE655U/LC-70LE650U/ LC-70C6500U Long screws 3 2 1 1 FRONT ■ LC-60LE657U/LC-60LE655U/LC-60LE650U/ LC-60C6500U Long screws 3 2 1 1 FRONT 3 1 Insert the stand into the openings on the bottom of the TV. • Make sure that the stand is firmly inserted into the TV. Improper installation may result in tilting of the TV set. 2 Insert and tighten the 4 screws into the 4 holes on the rear of the TV. Soft cushion 2 Short screws 2 1 1 Attaching the Stand (for the 90/80 Inch Models) Building the Work Table Before attaching the stand to the TV, build a work table on which to rest the TV. • To build the table, use the cushioning materials used in the packaging. • Of the cushioning materials used, TOP-C is also used during stand unit assembly. Be sure to assemble the stand unit before building the work table. TOP-L TOP-R 2 The case is equipped with push-in tabs to hold the cushioning materials in place. Push in the tabs (2 for each location) to secure the cushioning materials in the case. Push-in tabs TOP-C FRONT 1 Insert each of the cushioning materials in the respective directions shown in the figure. • Insert TOP-L and TOP-R into the left and right sides of the case respectively. • Insert TOP-C to fit between the lines on the other side of the case. TOP-R TOP-L CASE LINE ■ LC-90LE657U TOP-L CASE LINE TOP-R JOINT TOP-C Attach the joints and close the case. 1 Insert a joint into the hole on the side of the case. 2 Pressing the tab, fix the joint into place. TOP-C 1 2 3 After you have built the work table, spread a blanket or similar soft cloth over the table and then lay the TV display down on the covered table before attaching the stand to the TV. • Do not use a small table for this. • Refer to the operation manual for information on attaching the stand. • In the installation procedure, be careful not to catch your fingers between the TV set and the floor. • Do not remove the stand from the TV unless using an optional wall mount bracket to mount it. • After attaching the stand to the TV, do not hold the stand when you put up, set up, move or lay down the TV. 7