Sharp LC26D40U LC-26D40U LC-32D40U Operation Manual - Page 35

Other viewing options Freezing images Allows you to capture and freeze an image from a moving image that you are watching. Presetting remote control function You can operate the connected AV products (AV Receiver, Cable Box, SAT tuner, DTV, VCR, DVD, LD) using the presetting manufacturer function of your remote control unit. 1 Press FREEZE. • A moving image is captured. 2 Press FREEZE again to cancel the function. NOTE • When this function is not available, "NOT AVAILABLE" will display. • The still image automatically goes out after 30 minutes. • If you are using the freeze function and a broadcast activates the V-CHIP block, the freeze function will be cancelled and a V-CHIP block message will appear. Signal meter In order to receive digital air broadcasts, you need a digital broadcast antenna. You can confirm the antenna configuration through the "SIGNAL METER" menu. If necessary, adjust the direction of the antenna to obtain the maximum signal strength. Signal strength 1 Press MENU and the MENU screen displays. 2 Press / to select (SETUP). 3 Press / to select "SIGNAL METER". 4 Press / . • The strength of the digital signal is displayed. The signal information is based on the current channel. Presetting manufacturer codes 1 Press FUNCTION until the LED for your device lights up. 2 After the LED for your device lights up, press FUNCTION and DISPLAY at the same time to enter the code registration mode. The LED will blink. 3 Press 0-9 to enter the manufacturer code. (See page 36.) • Preset mode is finished once the LED no longer lights up. 4 After registering the code, the LED will stop blinking then turn off after one second. (If you perform an incorrect operation, the LED will blink quickly then turn off.) SIGNAL METER CHANNEL (DIGITAL) 23.002 40 5 Press EXIT to return to the normal screen. 35