Sharp LL172GB Operation Manual - Page 14

Connecting the monitor and turning the monitor on and off CAUTION! - When connecting, ensure that both the monitor and computer are switched off. - Be careful not to over bend the cable or add extension cords as this could lead to a malfunction. Connecting the monitor to a computer Analog connection [LL-172A] Connect the accessory analog signal cable to the analog RGB output terminal of the computer. Securing the cables [LL-172G] Use the supplied cable clamps to secure the cables connected to the terminals. The upper and lower cable clamps have different shapes. Check the shapes of the clamps before attaching them to the stand. CAUTION! - When adjusting the viewing angle, cables may be pulled. Therefore, ensure that the cables have sufficient slack. Analog RGB terminal (Mini D-sub 15 pin, 3 row) Analog signal cable - Paying attention to connector direction, firmly insert the signal cable vertically into the connector, and then tighten the screws at both sides. Orient the side of the clamp with the protrusion to the stand and attach the clamp. 14