Sharp M20X PG-M20X Operation Manual - Page 25
Connecting the Projector to a Computer, Connecting to a Computer, Using the, to 15-pin, D-sub Cable
![]() |
UPC - 074000358355
View all Sharp M20X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Connecting the Projector to a Computer Setup and Connections Connecting to a Computer Using the DVI to 15-pin D-sub Cable 1 Connect the projector to the computer using the supplied DVI to 15-pin D-sub cable. • Secure the connectors by tightening the thumbscrews. 2 To input audio signal, connect the projector to the computer using a ø3.5 mm stereo audio cable (commercially available or available as Sharp service part QCNW-4870CEZZ). Note • See page 75 "Computer Compatibility Chart" for a list of computer signals compatible with the projector. Use with computer signals other than those listed may cause some of the functions not to work. • When connecting the projector to a computer in this way, select "RGB" for "Signal Type" in the "Picture" menu. See page 40. • A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest Sharp Authorized Projector Dealer or Service Center. Supplied accessory DVI to 15-pin D-sub cable To RGB Output port To Audio Output port Notebook computer 2 ø3.5 mm stereo audio cable (commercially available or available as Sharp service part QCNW-4870CEZZ) 1 DVI to 15-pin D-sub cable Connecting the thumbscrew cables I Connect the thumbscrew cable making sure that it fits correctly into the port. Then, firmly secure the connectors by tightening the screws on both sides of the plug. I Do not remove the ferrite core attached to the D VI to 15-pin D-sub cable. Ferrite core -21
![](/manual_guide/products/sharp-pg-m20x-pgm20x-operation-manual-ad9e8f5/25.png)