Sharp MS722 Service Manual - Page 22

MD-MS722/C/W/MS721W - 22 - Continuous Playback • Continuous playback from current pickup position T PLAY : Continuous playback menu PLAY S Q # # # # A P # # # # : Continuous playback (pit section) : Continuous playback (groove section) # # # # : Address • Continuous playback from any address T PLAY DISP : Continuous playback menu Ad 0 0 5 0 : Start address setting PLAY S Q # # # # A P # # # # : Continuous playback (pit section) : Continuous playback (groove section) # # # # : Address * When the [STOP] key is pressed in specific menu, the "TEST MODE STOP" state is set. * In the start address set state the start address changes as follows when the [DISP] key is pressed. 0 0 5 0 H (initial value) DISP Ad0 0 5 0 0 3 C 0 H DISP Ad0 3 C 0 0 7 0 0 H DISP Ad0 7 9 0 0 8 A 0 H Ad0 8 A 0 DISP * In the start address setting state the start address change digit changes when the [BASS] key is pressed. 1st digit (initial value) 2nd digit 3rd digit BASS BASS Ad0 0 5 0 Ad0 0 5 0 Ad0 0 5 0 BASS * In the start address set state the value of selection digit changes in the range of "0h to Fh" when the [SKIP UP/DOWN] key is pressed * In the continuous playback state the number of jump lines changes as follows shown the [BASS] key is pressed. 1 (initial value) BASS 1 T R 10 1 0 T R 384 BASS 3 8 4TR BASS * When the [SKIP UP] key is pressed in the continued playback mode, jump of specified number of lines occurs in the external periphery direction. If the key is held down jump occurs continuously (100 ms cycle). * When the [SKIP DOWN]key is pressed in the continuous playback mode, jump of specified number of lines occurs in the internal periphery direction. If the key is held down, jump occurs continuously (100 ms cycle). Continuous Rrecord • Continuous record from the current pickup position T REC PLAY : Continuous record menu AP# # # # : Continuous record # # # #: Address • Continuous record playback from any address T REC PLAY : Continuous record menu Ad 0 0 5 0 PLAY : Start address setting AP# # # # : Continuous record # # # #: Address * When the [STOP] key is pressed in specific menu, the "TEST MODE STOP" state is set. * In the start address set state the start address changes as follows when the [DISP] key is pressed. 0 0 5 0 H (initial value) 0 3 C 0 H 0 7 0 0 H 0 8 A 0 H A d 0 0 5 0 DISP A d 0 3 c 0 DISP A d 0 7 0 0 DISP A d 0 8 A 0 DISP * In the start address setting state the start address change digit changes when the [BASS] key is pressed. 1st digit (initial value) A d 0 0 5 0 BASS 2nd digit A d 0 0 5 0 BASS 3rd digit Ad0 0 5 0 BASS * In the start address set state the value of selection digit changes in the range of 0h to Fh when the [SKIP UP/DOWN] key is pressed. * In the continuous record state and start address set state the record laser power changes in the range of "0h to Fh" when the [VOL UP/DOWN] key is pressed.