Sharp PN-E603 PN-E603 PN-E703 Quick Start Guide - Page 9
Turning Power On/Off
View all Sharp PN-E603 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
ENGLISH Turning Power On/Off Caution • Turn on the monitor first before turning on the PC or playback device. Turning on the main power Main power switch Caution • The main power must be turned on/off with the main power switch. Do not connect/disconnect the power cord or turn the breaker on/off while the main power switch is on. • When switching the main power switch or the POWER button off and back on, always wait for at least 5 seconds. • For a complete electrical disconnection, pull out the main plug. Turning power on/off Press the POWER button or POWER switch to turn the power ON/OFF. nMode setting When the monitor is turned on for the first time after being shipped from the factory, the mode setting screen will be displayed. (1)Press or to select YES or NO. (2)Press . ENTER YES: • STANDBY MODE is set to LOW POWER. • Compared to when set to STANDARD, the current consumption is reduced while the monitor is in standby mode/input signal waiting mode, but the startup/return time from standby mode/input signal waiting mode becomes longer. • While the monitor is in standby mode, control via LAN will be disabled. • While the monitor is in standby mode/input signal waiting mode, only certain RS-232C commands can be used. • Depending on the input signal, the monitor may not switch to input signal waiting mode and may not return from input signal waiting mode. NO: • STANDBY MODE is set to STANDARD. • Compared to when set to LOW POWER, the startup/ return time from standby mode/input signal waiting mode is reduced, but more power will be consumed in standby mode/input signal waiting mode. nDate/time setting • If the time has yet to be set when the monitor is first turned on, the date/time setting screen appears. Set the date and time. DATE/TIME SETTING // : : 01 / 01 / 20 15 12 : 00 AM Status Green lit Orange lit Green flashing Power switch Power LED Status of the monitor Power on Power off (Standby mode) Input signal waiting mode Accessing the operation panel OK···[ENTER] CANCEL···[RETURN] 1. Press or to select the date and time, and press or to change the numerical values. 2. Press ENTER . • Be sure to set the date and time. • The date/time setting screen will close automatically if no operation is performed for about 15 seconds. The date and time can be set using DATE/TIME SETTING from the SETUP menu when the date/time setting screen disappears. TIPS • Set the date in "Month/Day/Year" order. • Set the time on a 12-hour basis. • The clock is maintained by the internal battery. • If you already set the time but the date/time setting screen appears when the power is turned on, the internal battery may be exhausted. Please contact an authorized SHARP servicing dealer or service center for assistance with battery replacement. • Estimated service life of the internal battery: About 5 years (depending on monitor operation) • The initial battery was inserted at the factory when the monitor was shipped, so it may run out of power before its expected operation life. 7E