Sharp PN-Y556 PN-Y326 PN-Y436 PN-Y496 PN-Y556 Quick Start Guide - Page 6

SAFETY INSTRUCTION - D o not use the monitor where there is a lot of dust, where humidity is high, or where the monitor may come into contact with oil or steam. Do not use in an environment where there are corrosive gases (sulfur dioxide, hydrogen sulfide, nitrogen dioxide, chlorine, ammonia, ozone, etc.). As this could lead to fire. - E nsure that the monitor does not come into contact with water or other fluids. Ensure that no objects such as paper clips or pins enter the monitor as this could lead to fire or electric shock. - D o not place the monitor on top of unstable objects or in unsafe places. Do not allow the monitor to receive strong shocks or to strongly vibrate. Causing the monitor to fall or topple over may damage it. - D o not use the monitor near heating equipment or in places where there is likelihood of high temperature, as this may lead to generation of excessive heat and outbreak of fire. - D o not use the monitor in places where it may be exposed to direct sunlight. Risk of cabinet deformation and failure if the monitor is used in direct sunlight. - P lease be sure to constantly remove dust and garbage that has attached to the ventilation opening. If dust collects in the ventilation opening or the inside of the monitor, it may lead to excessive heat, outbreak of fire, or malfunction. Please request a cleaning of the inside of the monitor from an authorized SHARP servicing dealer or service center. - T he AC outlet shall be installed near the equipment and shall be easily accessible. The Power Cord - Use only the power cord supplied with the monitor. - D o not damage the power cord nor place heavy objects on it, stretch it or over bend it. Also, do not add extension cords. Damage to the cord may result in fire or electric shock. - D o not use the power cord with a power tap. Adding an extension cord may lead to fire as a result of overheating. - D o not remove or insert the power plug with wet hands. Doing so could result in electric shock. - Unplug the power cord if it is not used for a long time. - D o not attempt to repair the power cord if it is broken or malfunctioning. Refer the servicing to the service representative. Supplied Components If any components are missing, please contact your dealer.  Liquid Crystal Display Monitor: 1  Remote control unit: 1  Power cord: 1  R-6 battery ("AA" size): 2  CD-ROM (Utility Disk for Windows): 1  Setup Manual (this manual): 1  Cable clamp: 2  USB flash drive cover: 1  SD card cover: 1  Cover screw (M3 × 6 mm): 2  Logo sticker: 1 * SHARP Corporation holds authorship rights to the Utility Disk program. Do not reproduce it without permission. * For environmental protection! Do not dispose of batteries in household waste. Follow the disposal instructions for your area. Preparing the Remote Control Unit 1. Press the cover gently and slide it in the direction of the arrow. 2. See the instructions in the compartment and put in the supplied batteries (R-6 ("AA" size) x 2) with their plus (+) and minus (-) sides oriented correctly. 3. Close the cover. E4