Sharp R-520JK KB-5121KS , KB-5121KK , KB-5121KW Installation Instructions - Page 4
Installation
View all Sharp R-520JK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
INSTALLATION MANUAL INSTALLATION • Review and plan ahead all safety instructions, cabinet clearances and dimensions, power supply placement and electrical requirements before installing. • Proper installation is the responsibility of the installer and product failure due to improper installation is not covered by warranty. Note: This appliance must be properly grounded Attention Installer: This appliance must be hard wired (direct wired) into an approved junction box. A plug and receptacle is NOT permitted on this product. A SELECTING 208 OR 240 VOLT CONNECTION This appliance can be set for 208V or 240V. The voltage setting for your appliance is pre-set at 240V from the factory. Follow these steps to change the voltage setting. 1 Locate the voltage switch on the left side of the appliance (facing the front). See Figure 4. 2 Remove the screw and rotate the switch plate 180˚ as indicated in the Figure 5. 3 Reinsert the switch plate and replace screw as indicated in Figure 6. The voltage setting is indicated by the visible marking. B ADJUSTING ANTI-TIP BRACKET Measure the thickness of the counter. See Figure 7. Locate the Anti-Tip Bracket on the backside of the appliance. See Figure 8. Loosen screws and adjust space between the glass cooktop and bracket to match the counter thickness plus 1/16". See Figure 9. Tighten the screws to secure the bracket at the correct counter height dimension. Figure 7 Measure thickness Anti-Tip bracket Loosen screws to adjust Back of unit Figure 8 240V 208V Figure 4 Screw Figure 5 Screw 180˚ Figure 6 Countertop thickness +1/16" from bottom of cooktop glass bracket to top of Anti-Tip bracket Figure 9 4