Sharp R1405 R-1405 , R-1406 Microwave Operation Manual - Page 8

UNPACKING AND INSTALLATION INSTRUCTIONS 5 TOOLS RECOMMENDED FOR INSTALLATION • Phillips Screwdriver • Electric Drill • 1/2", 5/8" and 3/32" Drill Bits • 1-1/2" Wood Bit or Metal Hole Cutter (if metal cabinet is used) • Saw to cut exhaust opening (if needed) • Protective Drop Cloth for product and range - you may also use carton for protection • Scissors • Pencil • Measure • Tape 6 INSTALLATION HARDWARE The INSTALLATION HARDWARE items 1 - 5 are in a small bag. Items 6 - 9 are packed separately. All items are in a small carton packed below the oven. ITEM 1 2 3 4 5 6 7 8 9 Name Wood Screw 5 X 30 mm Toggle Bolt with nuts #10 - 24 x 50 mm Top Cabinet Screw 5 X 85 mm Tapping Screw 4 x 12 mm Flat Washer 30 mm diameter Rear Cushion Exhaust Damper Assembly Scale Plate Grease Filter Quantity 4 4 2 1 2 1 1 2 2 Part code XTSS750P35000 LX-BZ0195WRE0 XBPS750P85000 XOTS740P12000 XWH750-16300 PCUSUB059MRP0 FFTA-B005MRK0 LANG-B002MRP0 PFIL-B002MRE0 Figure 4 Parts shown not to common scale. 7 PREPARATION OF THE OVEN Seperate mounting plate from oven by removing two screws. See illustration below. Save these screws for use in section 11 Mounting Oven to Wall, step 5. Mounting Plate Back of Microwave