Sharp XL-HP515 Service Manual - Page 5
Adjustments, [1] Adjustment, 1. Mechanism Tuner Cd - service manual
View all Sharp XL-HP515 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
AXSMECeLuaHrdH-vrHkiAioPcePe5tP51M1T55aEnuRal2. ADJUSTMENTS XL-HP515 [1] ADJUSTMENT 1. MECHANISM SECTION • Driving Force Check Torque Meter Play: TW-2111 Specified Value Over 80 g • Torque Check Torque Meter Play: TW-2111 Fast forward: TW-2231 Rewind: TW-2231 Specified Value 30 to 80 g.cm 70 to 180 g.cm 70 to 180 g.cm 2. TUNER SECTION fL: Low-range frequency fH: High-range frequency • AM IF/RF Signal generator: 400 Hz, 30%, AM modulated Test Stage AM IF AM Band Coverage AM Tracking Frequency 450 kHz - 990 kHz Frequency Display 1,602 kHz 531 kHz 990 kHz Setting/ Adjusting Parts T351 (fL): T306 1.1 ± 0.1 V (fL): T303 Instrument Connection *1 *2 *1 *1. Input: Antenna Output: TP302 *2. Input: Antenna Output: TP301 • FM RF Signal generator: 1 kHz, 40 kHz dev., FM modulated Test Stage FM Band Coverage FM RF Frequency - 98.00 MHz (10-30 dB) Frequency Display 87.50 kHz 98.00 MHz Setting/ Adjusting Point T301 (fL): 1.3 ± 0.1 V L312 Instrument Connection *1 *2 *1. Input: Antenna Output: TP301 *2. Input: Antenna Output: Speaker terminal • FM IF Signal generator: 10.7MHz FM modulated Test Stage IF Frequency 10.7 MHz Frequency Display 98 MHz Setting/ Adjusting Point T302 (Turn the core of transformer T302 fully counterclock wise) Instrument Connection *1 *1. Input: Antenna Output: TP301 • Tape Speed Normal speed Test Tape MTT-111 Adjusting Point Variable Resistor in motor. Specified Value 3,000 ± 30 Hz Instrument Connection Speaker Terminal (Load resistance: 6 ohms) TAPE MECHANISM Tape Motor Variable Resistor in motor Figure 1 TUNER PWB-C SO302 FM ANTENNA TERMINAL AM LOOP ANTENNA CNP301 IC301 AM TRACKING fL L312 T303 TP301 T306 20 C393 T302 FM RF FM IF AM BAND T301 COVERAGE fL FM OSC T351 AM IF TP302 IC302 IC303 R356 Figure 2 ADJUSTMENT POINTS 3. CD SECTION • Adjustment Since this CD system incorporates the following automatic adjustment functions, readjustment is not needed when replacing the pickup. Therefore, different PWBs and pickups can be combined freely. Each time a disc is changed, these adjustments are performed automatically. Therefore, playback of each disc can be performed under optimum conditions. Items adjusted automatically 1) Offset adjustment (The offset voltage between the head amplifier output and the VREF reference voltage is compensated inside the IC.) * Focus offset adjustment * Tracking offset adjustment 2 - 1