Sharp XL-MP131 XL-MP131 Operation Manual - Page 37

Troubleshooting chart - player

Page 37 highlights

Subwoofer connection When a commercially available speaker with a built-in amplifier is connected to this unit, you can enjoy sound with emphasized bass. Connect an RCA cord from a commercially available speaker with a built-in amplifier to the SUBWOOFER PRE-OUT jack. ANTENNA AM FM 75 OHMS GND LOOP VIDEO/AUX IN RIGHT LEFT RATED SPEAKER IMPEDANCE: 6 OHMS MIN. AC INPUT RIGHT LEFT SUBWOOFER PRE-OUT Troubleshooting chart Many potential problems can be resolved by the owner without calling a service technician. If something is wrong with this product, check the following before calling your authorized SHARP dealer or service center. General Symptom The clock is not set to the correct time. When a button is pressed, the unit does not respond. No sound is heard. Possible cause Did a power failure occur? Reset the clock. Set the unit to the power standby mode and then turn it back on. If the unit still malfunctions, reset it. Is the volume level set to "0"? Are the headphones connected? Are the speaker wires disconnected? XL-MP131 SPEAKERS References Speaker with a built-in amplifier CD player Symptom Playback does not start. Playback stops in the middle or is not performed properly. Playback sounds are skipped, or stopped in the middle of a track. Possible cause Is the disc loaded upside down? Does the disc satisfy the standards? Is the disc distorted or scratched? Is the unit located near excessive vibrations? Is the disc very dirty? Has condensation formed inside the unit? 37

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42

37
XL-MP131
References
±
Subwoofer connection
When a commercially available speaker with a built-in amplifier is
connected to this unit, you can enjoy sound with emphasized bass.
Connect an RCA cord from a commercially available speaker with a
built-in amplifier to the SUBWOOFER PRE-OUT jack.
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorized SHARP dealer or service center.
±
General
±
CD player
RATED SPEAKER IMPEDANCE:
6 OHMS MIN.
AC INPUT
ANTENNA
RIGHT
RIGHT
LEFT
GND
FM
75 OHMS
AM
LOOP
VIDEO/AUX
IN
SUBWOOFER
PRE-OUT
SPEAKERS
LEFT
Speaker with a
built-in amplifier
Symptom
Possible cause
z
The clock is not set to the
correct time.
z
Did a power failure occur? Reset
the clock.
z
When a button is pressed,
the unit does not respond.
z
Set the unit to the power stand-
by mode and then turn it back on.
z
If the unit still malfunctions, reset
it.
z
No sound is heard.
z
Is the volume level set to "0"?
z
Are the headphones connected?
z
Are the speaker wires discon-
nected?
Symptom
Possible cause
z
Playback does not start.
z
Is the disc loaded upside down?
z
Playback stops in the mid-
dle or is not performed
properly.
z
Does the disc satisfy the stan-
dards?
z
Is the disc distorted or
scratched?
z
Playback sounds are
skipped, or stopped in the
middle of a track.
z
Is the unit located near excessive
vibrations?
z
Is the disc very dirty?
z
Has condensation formed inside
the unit?