Sharp XV-Z15000 XV-Z15000 Operation Manual - Page 42

Computer Image Adjustment ("SIG-ADJ" Menu) The illustration shown here is for explanation and may be different from the actual on-screen display. Picture SIG-ADJ SCR-ADJ PRJ-ADJ Clock 0 Phase 0 H-Pos 0 V-Pos 0 Reset Resolution Auto Sync On *1 Signal Type Auto Video System Auto Video Setup 0 IRE *2 Dynamic Range Auto Signal Info : 1080P H : XX.X kHz/ V : XX.X Hz SEL./ADJ. RETURN ENTER END *1 If the input mode is S-VIDEO or VIDEO input, the display changes to the "Video System" screen. *2 Displayed when the input mode is HDMI input. 1Adjusting the Computer Image Use the SIG-ADJ function in case of irregularities such as vertical stripes or flickering in portions of the screen. Selectable items Description Clock Adjusts vertical noise. Phase Adjusts horizontal noise (similar to tracking on your VCR). H-Pos Centers the on-screen image by moving it to the left or right. V-Pos Centers the on-screen image by moving it up or down. Note • You can automatically adjust the computer image by setting "Auto Sync" in the "SIG-ADJ" menu to "On", or pressing AUTO SYNC on the remote control. • Depending on the type of input signal, the adjustment range for each setting may vary or the adjustment may not be available at all. • To reset all adjustment items, select "Reset" and press ENTER. 2Setting the Resolution Ordinarily, the type of input signal is detected and the correct resolution mode is automatically selected. However, for some signals, the optimal resolution mode in "Resolution" in the "SIG-ADJ" menu may need to be selected to match the computer display mode. Menu operation ⇒ Page 34 Note • Avoid displaying computer patterns which repeat every other line (horizontal stripes). (Flickering may occur, making the image hard to see.) • Information on the currently selected input signal can be confirmed in item 8 on page 41. 3Auto Sync (Auto Sync Adjustment) Selectable items On Off Description Auto Sync adjustment will occur when the projector is turned on or when the input signals are switched, when connected to a computer. Auto Sync adjustment is not automatically performed. Note • Auto Sync adjustment is also performed by pressing AUTO SYNC on the remote control. • When setting "Auto Sync" to "Off", and if AUTO SYNC is pressed, Auto Sync will be executed in "On" mode. If the button is pressed again within one minute, Auto Sync will be executed in "On" mode. • The Auto Sync adjustment may take some time to complete, depending on the image of the computer connected to the projector. • When the optimum image cannot be achieved with Auto Sync adjustment, use manual adjustments. 4Signal Type Setting When using an input mode of HDMI1, HDMI2, or COMPUTER, set the signal type to the corresponding input signal type (RGB or Component). Selectable items Auto Description Automatically selects the appropriate input signal between RGB and Component. RGB Component Set when RGB signals are received. Set when component signals are received. -40