Singer 14T967DC Quantumlock Instruction Manual 26 - Page 30

needle eye towards the rear of the machine.

Get Singer 14T967DC Quantumlock PDF manuals and user guides View all Singer 14T967DC Quantumlock manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

While holding thread with fingers, pass it between the tension discs and pull thread down to make certain it is properly located in between the tension discs 3. 3 3 Continue to thread points 4~8. Note: Slip thread into the rear slot on thread guides 5. Slip the thread into the slot of the Take-up Lever Cover 6. Slip the thread into the right slots for thread guides 7 and 8. Before threading eye of needle, make sure thread is in front of thread guide located on the bottom of the needle clamp for Cover stitch. Thread the eye of the right needle 9. Note: Use of tweezers in the accessory case will make needle eye threading easy. Draw about 10cm (4 inches) of thread through needle eye towards the rear of the machine. Place the thread to the back under the presser foot. 7 6 8 9 4 5 9 29

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
9
8
9
4
5
7
6
3
3
29
Continue to thread points 4~8.
Note: Slip thread into the rear slot on thread
guides 5. Slip the thread into the slot
of the Take-up Lever Cover 6. Slip the thread
into the right slots for thread guides 7 and 8.
Before threading eye of needle, make sure thread is
in front of thread guide
located on the bottom of the
needle clamp for Cover stitch.
Thread the eye of the right needle 9.
Note: Use of tweezers in the accessory case will
make needle eye threading easy.
Draw about 10cm (4 inches) of thread through
needle eye towards the rear of the machine.
Place the thread to the back under the presser
foot.
While holding thread with fingers, pass it between
the tension discs and pull thread down to make
certain it is properly located in between the
tension discs 3.