Singer 7363 CONFIDENCE Instruction Manual - Page 70
Performance Checklist
View all Singer 7363 CONFIDENCE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
5. PERFORMANCE CHECKLIST GENERAL PROBLEMS Machine does not sew. * Power switch is turned off.- Turn on the switch. * Buttonhole lever is not raised when sewing stitch patterns. - Raise buttonhole lever. * Buttonhole lever is not lowered when sewing buttonhole. - Lower buttonhole lever. * Bobbin winder is engaged. - Disengage bobbin winder (see page 14 - 15). Machine jams/knocks. * Thread is caught in hook.- Clean hook (see page 60 - 61). * Needle is damaged.- Replace needle (see page 22 - 23). Fabric does not move. * Presser foot is not lowered - Lower presser foot. * Stitch length is too short - Lengthen stitch length. * Darning plate is placed on needle place - Remove darning plate. STITCHING PROBLEMS Machine skips stitches. * Needle is not all the way up into needle clamp. - See page 22 - 23. * Needle is bent or blunt. - Replace needle (see page 22 - 23). * Machine is not threaded correctly. - See page 18 - 19. * Thread is caught in hook. - Clean hook (see page 60 - 61). Stitches are irregular. * Needle size is not correct for thread and fabric. - See page 22 - 23. * Machine is not threaded correctly. - See page 18 - 19. * Top thread tension is too loose. - See page 24 - 25. * Fabric is being pulled or pushed against machine feeding action. - Guide it gently. * Bobbin has not been wound evenly. - Rewind bobbin. Needle breaks. * Fabric is being pulled or pushed against machine feeding action. - Guide it gently. * Needle size is not correct for thread and fabric. - See page 22 - 23. * Needle is not all the way up into the needle clamp. - See page 22 - 23. * Twin needle is being used but stitch width is set too wide. - See page 62 - 63. THREAD PROBLEMS Thread bunches. * Top and bobbin threads are not drawn back under presser foot before starting seam. - Draw both threads back under presser foot about 6 inches (10 cm) and hold until a few stitches are formed. Needle thread breaks. * Machine is not threaded correctly. - See page 18 - 19. * Top thread tension is too tight. - See page 24 - 25. * Needle is bent. - Replace needle (see page 22 - 23). * Needle size is not correct for thread and fabric - See page 22 - 23. Bobbin thread breaks. * Bobbin case is not threaded correctly. - See page 16 - 17. * Lint accumulates in bobbin case or hook. - Remove lint (see page 60 - 61). Fabric puckers. * Top thread tension is too tight. - Adjust thread tension (see page 24 - 25). * Stitch length is too long for sheer or soft fabric. - Shorten stitch length. 64