Singer CE-250 Futura Instruction Manual - Page 74

ATTACHING EMBROIDERY UNIT 1 Always be sure to turn off power to machine CAUTION before installing embroidery unit. 1. Turn off power to machine. Remove connector cap from machine. * Re-install connector cap before using machine for general sewing. 2 2. Slide the embroidery unit onto machine fitting connectors on the machine and embroidery unit. Slide the embroidery unit as far as it will go until it clicks into place. Hold handle of embroidery unit and pull it toward the left direction, and check that embroidery unit does not detach. Note: If embroidery unit is not securely installed, finished shape of pattern may deform. Make sure that embroidery unit is pushed in as far as it will go. Connector cap Couvercle de connecteur Tapa de conector Connector Connecteur Conector REMOVING EMBROIDERY UNIT Handle Poignée Mango 1 Always be sure to turn off power to machine CAUTION before installing embroidery unit. * Turn off power to machine. * Remove embroidery hoop from machine. (Refer to pages 82 - 83.) 2 1. Holding handle of embroidery unit, carefully slide toward the left while pressing release lever. Note: Do not pull carriage when removing embroidery unit. Release lever Support de cerceau Palanca de liberación Handle Poignée Mango 2. Insert the tab at the bottom of connector cap first, and push in the top of the connector cap with your finger as illustrated. Connector cap Couvercle de connecteur Tapa de conector Connector cap Couvercle de connecteur Tapa de conector tab Languette Lengüeta 74