Smeg CMSU6451X Instruction Manual - Page 9

Take care to avoid scalds). NOTE 1: If the coffee is delivered a drop at a time or not at all, turn the grinding adjustment knob (fig. 12) one click clockwise (see "Adjusting the coffee mill"). Proceed one click at a time until coffee delivery is satisfactory. NOTE 2: If the coffee is delivered too fast and the cream is not satisfactory, turn the grinding adjustment knob (fig. 12) one click anticlockwise (see "Adjusting the coffee mill"). Avoid turning the grinding adjustment knob excessively otherwise when you select 2 cups, the coffee may be delivered a drop at a time. NOTE 3: Tips for a hotter coffee: • When you turn the appliance on, if you want to make a short coffee (less than 60 cl / 20.29 oz), rinse the cups with hot water to preheat the cups. If more than 2/3 minutes have passed since the last coffee was made, before requesting another coffee, you must preheat the infuser by pressing the button (C4) (fig. 13). Deliver the water into the underlying drip tray or alternatively use this water to fill (and then empty) the cup to be used for the coffee, so as to preheat it. • Unless preheated, do not use excessively thick cups as they will absorb too much heat. • Preheat the cups by rinsing them with hot water. NOTE 4: While the appliance is making coffee, delivery can be interrupted at any moment by pressing the previously selected button, (C8), (C9) or (C10). NOTE 5: As soon as delivery is finished, to increase the quantity of coffee in the cup, just hold down the previously selected coffee button, (C8), (C9) or (C10), until the required amount is reached (this must be done within 3 seconds after completion of delivery). NOTE 6: When the appliance displays "FILL TANK", fill the tank with water or the appliance will not deliver coffee. (It is normal for there to be a little water left in the tank when the message is displayed). NOTE 7: After about 14 single (or 7 double) coffees, the appliance displays "EMPTY GROUNDS CONTAINER", indicating that the grounds container is full and must be emptied and cleaned. Until the grounds container has been cleaned, the appliance continues to display the message and coffee cannot be made. Even if not full, the empty waste coffee container message is displayed 72 hours after the first coffee has been delivered. For the 72 hours to be calculated correctly, the machine must never be turned off with the main switch in the 0 position. To clean, open the service door on the front of the appliance by pulling the handle (fig. 14), extract the drip tray (fig. 15), empty and clean. When cleaning, always extract the drip tray completely to avoid it falling when the grounds container is removed. Empty the grounds container and clean thoroughly to remove all residues left on the bottom. Important! when removing the drip tray, the grounds container MUST be emptied, even if it is not completely full. If this is not done, when you make the next coffees, the grounds container may fill up more than expected and clog the machine. NOTE 8: Never extract the water tank while the machine is delivering coffee. If it is removed, it will not be possible to make the coffee and the appliance will display "GROUND TOO FINE ADJUST MILL and INSERT WATER SPOUT AND PRESS OK". To use the appliance again, insert the hot water spout (fig. 4) if not already in position, then press the OK button (C5) and deliver water from the spout for a few seconds. CHANGING THE QUANTITY OF COFFEE IN THE CUP The appliance is set by default to automatically make the following types of coffee: • short coffee when the button (C8) is pressed; • standard coffee when the button (C9) is pressed; • long coffee when the button (C10) is pressed. To change these quantities, proceed as follows: • hold down the button corresponding to the quantity you want to change, (C8), or (C9) or (C10), for at least 3 seconds then release until the message "PROGRAM QUANTITY"is displayed and coffee delivery commences; • when the coffee in the cup reaches the required level, press the same button again to memorise the new amount. The appliance is now reprogrammed with the new settings and displays: "READY". 13