Smeg CPF36UGMYW Instruction Manual 2 - Page 8
Unpacking, moving and, positioning the range
View all Smeg CPF36UGMYW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Installation An air curtain or other overhead range hood, which operates by blowing a downward airflow onto a range, shall not be used in conjunction with the gas range unless the hood and range have been designed, tested in accordance with ANSI Z21.1 and listed by an independent testing laboratory for combination use. This type of ventilation system may cause ignition and combustion problems with the gas cooking appliance resulting in personal injury or unintended operation. 1.3 Unpacking, moving and positioning the range CAUTION: This unit is designed as a cooking appliance. For safety purposes, never use it for warming the room or as a space heater. • It is recommended that the grates, the griddle plate and burner heads, burner caps, front kick panel and oven racks be removed to facilitate handling. This will reduce the weight for moving. • When positioning the appliance during installation, do not use the door handle to lift up or move this appliance. • Remove the outer carton and packing material from the shipping base. • Remove angle-mounting brackets from the range. • Due to the weight, a dolly/fork lift with soft rubber tread wheels should be used to move this unit. The weight must be supported uniformly across the bottom. • The floor under the legs should be protected (wood, strips, carpet, paneling, etc.) before pushing the unit into position. • The anti-tip device must be installed, and the gas and electrical connections should be made before the range is placed in its final position. • Ensure that the burner caps are correctly positioned on the burner bases on the rangetop. • Legs should be installed near to where the appliance will be used as they are not secure for long transit. Keep the unit raised so the legs can be screwed into their couplings, then lower the range gently to prevent the legs and mounting hardware from being subject to any undue strain. Instead of tilting the unit, it is recommended that a pallet or lift jack be used. 10