Smeg CVIU338RX1 Instruction manual - Page 5

appliance installation

Page 5 highlights

pin. • Do not use an adapter plug. • Do not use an extension cord. • Do not twist or tie the power cord. • Do not pull or bend the power cord. • Do not damage the power cord when moving the appliance. • To avoid any danger, if the power supply cable is damaged, contact the technical assistance service immediately, that will replace the cable to prevent any risk. • Never unplug an appliance device by pulling on the power cord. Always grasp the plug firmly when pulling it out of the outlet to avoid damaging the power cord. • Always disconnect the appliance from the power supply when troubleshooting, servicing, replacing bulbs, or cleaning. • Have a qualified electrician check the wall outlet and circuit to make sure the outlet is properly grounded. • Qualified personnel should carry out the installation and servicing in compliance with existing regulations. Service personnel should disconnect power before working on this appliance. • A qualified technician must complete the electrical connection. • Before any operation on the appliance (installation, maintenance, positioning or movement) always wear PPE. • Before performing any operation on the appliance, switch off the power supply. • Do not attempt to repair or replace any part of this appliance unless specifically recommended in this manual. Any other maintenance must be performed by a qualified technician. • Do not damage or drill the coolant pipes. • Do not damage the coolant circuit. • Do not use sharp instruments, alcohol, flammable liquids, or abrasive cleaners to remove tape glue. Clean only with warm water. • CAUTION: Keep ventilation openings in the appliance enclosure or built-in structure free from obstructions. • CAUTION: Do not use mechanical, electrical, or chemical products other than those recommended by the manufacturer to speed up the defrosting process. • Do not dispose of packaging material. Separate the various scraps by type and consign them to the nearest separate waste collection center. 91477A923/A IMPORTANT SAFETY INSTRUCTIONS - 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17

IMPORTANT SAFETY INSTRUCTIONS
-
7
91477A923/A
e
pin.
Do not use an adapter plug.
Do not use an extension cord.
Do not twist or tie the power
cord.
Do not pull or bend the power
cord.
Do not damage the power
cord when moving the
appliance.
To avoid any danger, if the
power supply cable is
damaged, contact the
technical assistance service
immediately, that will replace
the cable to prevent any risk.
Never unplug an appliance
device by pulling on the power
cord. Always grasp the plug
firmly when pulling it out of the
outlet to avoid damaging the
power cord.
Always disconnect the
appliance from the power
supply when troubleshooting,
servicing, replacing bulbs, or
cleaning.
Have a qualified electrician
check the wall outlet and circuit
to make sure the outlet is
properly grounded.
Qualified personnel should
carry out the installation and
servicing in compliance with
existing regulations. Service
personnel should disconnect
power before working on this
appliance.
A qualified technician must
complete the electrical
connection.
Before any operation on the
appliance (installation,
maintenance, positioning or
movement) always wear PPE.
Before performing any
operation on the appliance,
switch off the power supply.
Do not attempt to repair or
replace any part of this
appliance unless specifically
recommended in this manual.
Any other maintenance must be
performed by a qualified
technician.
Do not damage or drill the
coolant pipes.
Do not damage the coolant
circuit.
Do not use sharp instruments,
alcohol, flammable liquids, or
abrasive cleaners to remove
tape glue. Clean only with
warm water.
CAUTION: Keep ventilation
openings in the appliance
enclosure or built-in structure free
from obstructions.
CAUTION: Do not use
mechanical, electrical, or
chemical products other than
those recommended by the
manufacturer to speed up the
defrosting process.
Do not dispose of packaging
material. Separate the various
scraps by type and consign them
to the nearest separate waste
collection center.