Smeg KLF04RDUS User manual - Page 13

Press the START/STOP key

Get Smeg KLF04RDUS PDF manuals and user guides View all Smeg KLF04RDUS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

EN Use 4. Fill the kettle with the required quantity of water, referring to the marks on the level indicator (2). 2 6. Insert the plug into the power socket. All the LEDs will come on and a beep will sound to indicate that the appliance has been turned on. The LEDs of the START/ STOP and Keep Warm keys switch off after 2 seconds and the default temperature set is 212°F. 7. Use the temperature selector (3) to select the required temperature. Move the temperature selector to the left to decrease the temperature. Move the temperature selector to the right to raise the temperature. 5. Close the lid again and place the kettle back on its base. 4 3 8. Press the START/STOP key (4): the LED will come on and a beep will sound to indicate that the cycle has started. The LED of the selected temperature will turn on, while those for the temperatures below the one set will flash and then turn on progressively as the water reaches the corresponding temperature. 9. When the water reaches the set temperature, the corresponding LED and those of the temperatures below it will all be lit. The LED of the START/STOP key turns off and the appliance beeps to indicate the end of the cycle. 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
Use
15
EN
4. Fill the kettle with the required quantity of
water, referring to the marks on the level
indicator (
2
).
5. Close the lid again and place the kettle
back on its base.
6. Insert the plug into the power socket. All
the LEDs will come on and a beep will
sound to indicate that the appliance has
been turned on. The LEDs of the START/
STOP and Keep Warm keys switch off
after 2 seconds and the default
temperature set is 212°F.
7. Use the temperature selector (
3
) to select
the required temperature. Move the
temperature selector to the left to
decrease the temperature. Move the
temperature selector to the right to raise
the temperature.
8. Press the START/STOP key (
4
): the LED
will come on and a beep will sound to
indicate that the cycle has started. The
LED of the selected temperature will turn
on, while those for the temperatures
below the one set will flash and then turn
on progressively as the water reaches
the corresponding temperature.
9. When the water reaches the set
temperature, the corresponding LED and
those of the temperatures below it will all
be lit.
The LED of the START/STOP key turns off
and the appliance beeps to indicate the
end of the cycle.
2
3
4