Smeg SC712U Instruction Manual - Page 4
PREPARING THE BUILT–IN OVEN, Instructions for the Installer
View all Smeg SC712U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Instructions for the Installer 3. PREPARING THE BUILT-IN OVEN WARNING HEAVY WEIGHT HAZARD - Have two or more people move and install the oven - Failure to do so can result in back injury or other personal injuries. The oven is designed for installation into any type of cabinetry as long as it is heat-resistant. Proceed according to the dimensions shown in Pictures 1, 2 and 3. For installing under a countertop, use the dimensions shown in Picture 3. For installing under a countertop beneath a cooktop with controls connected to the oven, ensure a minimum clearance from any side walls of at least 110 mm as shown in Picture 1. For installing in a column, observe the dimensions shown in Picture 2 allowing for a clearance of 80 to 90 mm at the top and sides of the column. Tighten the four screws (ref. A) inside the frame to secure (Pic. 1). For installing under a separate cooktop, allow for a rear and bottom clearance as shown in Picture 1 (ref. B). See instructions regarding fitting and securing the cooktop. It is important to follow these instructions before and during oven installation: • Decide on the final location of the oven. Locate the existing wiring to avoid drilling into or severing wiring during installation. • To avoid damage to the floor, place the oven on cardboard prior to installation. Do not lift by the door handle or any part of the frame or trim. • Remove the shipping materials and tape from the oven. • Remove the appliance literature included with the packaging. • Remove racks and other parts from inside the oven and set aside. • Slide the oven on the cardboard close to the oven's final location. • Remove the oven door (see paragraph "9.2 Removing the door" in the Instructions for the User booklet) IMPORTANT: Use both hands to remove the oven door. 6