Snapper 400Z Operater's Manual - Page 15
Operation - zero turn mowers
View all Snapper 400Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Operation Operation General Operating Safety Before first time operation: • Be sure to read all information in the Safety and Operation sections before attempting to operate this tractor and mower. • Become familiar with all of the controls and how to stop the unit. • Drive in an open area without mowing to become accustomed to the unit. WARNING Never operate on slopes greater than 15°. Select slow ground speed before driving onto a slope. Use extra caution when operating on slopes with a rear-mounted grass catcher. Mow across the face of slopes, not up and down, use caution when changing directions and DO NOT START OR STOP ON SLOPE. Checks Before Starting • Check that crankcase is filled to full mark on the engine WARNING oil dipstick (A, Figure 3). See the engine Operator's Never allow passengers to ride on the unit. Manual for instructions and oil recommendations. • Fill the fuel tanks with fresh fuel. Refer to engine manual Before leaving the operator's position for any for fuel recommendations. reason, engage the parking brake, disengage the PTO, stop the engine and remove the key. To reduce fire hazard, keep the engine, tractor and mower free of grass, leaves and excess r n grease. Do not stop or park tractor over dry leaves, grass or combustible materials. fo tio Gasoline is highly flammable and must be handled with care. Never fill the tank when the t c engine is still hot from recent operation. Do not allow open flame, smoking or matches in the o u area. Avoid over-filling and wipe up any spills. • Make sure all nuts, bolts, screws and pins are in place and tight. • Check the tire pressures. See Check Tire Pressures. • Adjust the seat position, and make certain you can reach all controls from operator's position. See Seat Adjustment • Adjust the height of the mower deck to the desired position. See Mowing Height Adjustment. WARNING N rod Do not load this zero-turn rider on a trailer or p truck using two separate ramps. Only use e a single ramp that is at least one foot wider than the width of the rear wheels of this rider. R This rider has a zero turning radius and the A rear wheels could fall off the ramps, or the rider could tip over injuring the operator or bystanders. Figure 3. Checks Before Starting A. Engine Oil Dipstick B. Fuel Valve Selector 13