Snapper CP2155HV Operater's Manual - Page 12

Operation (Continued) ! WARNING ! DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. Installing the Grass Bag (Slide Closure Type) 1. Install the grass bag adapter. Refer to the Section entitled "Installing the Grass Bag Adapter". 2. Install the grass bag by sliding the connector (A, Figure 14) over the adapter flange. 3. Attach the grass bag hooks (B) over the middle handle cross bar. Dumping the Grass Bag 1. Grasp the bag connector and bag handle. Lift up on the bag handle, removing it from the mower handle. Then lift up on the bag connector, removing it from the adapter flange. 2. Open the bag by pulling the bag slider (A, Figure 15) off of the Z-fold at the rear of the bag (B). 3. To close the bag, fold the rear of the bag into the former Z-shape, keeping the edges aligned. Grasp the edge of the Z-fold, and while holding the slider, pull the Z-fold fully into the slider. NOTE: An illustration of the Z-Fold is attached to the bag. A B B A Figure 14: Installing the grass bag Figure 15: Removing the bag slider ! WARNING ! Grass Catcher bags used on SNAPPER products are made of woven fabric, and are subject to deterioration and wear during normal usage. Check condition of bag before each use. Immediately replace worn or damaged catcher bags with only bags recommended by SNAPPER. The grass catcher is optional equipment on some models. Operation 10 www.snapper.com