Sony AITE200ULSBK Operating Instructions - Page 18

Cleaning Request Mode Automatic cleaning requests can be enabled by a DIP switch. When switch 6 is ON, cleaning requests are enabled. When enabled, the "CLEANING REQUEST" LED on the front panel lights after every 100 hours of operation. When this LED lights, clean the drive with a head cleaning cartridge. Note To maintain the drive in optimum condition in environments affected by dust and other contaminants, we recommend keeping cleaning requests enabled. ON OFF 12345678 1 Drive Mode 2 Drive Mode 3 Drive Mode 4 Drive Mode 5 Reserved 6 Periodic Cleaning Req (ON) 7 DC Control (1) 8 DC Control (2) Emulation Mode* (only for AITe130V-UL and AITe90V-UL) To enable Emulation Mode, set position 1 - 4 Drive Mode switches to ON. ON OFF 12345678 1 Drive Mode (ON) 2 Drive Mode (ON) 3 Drive Mode (ON) 4 Drive Mode (ON) 5 Reserved 6 Periodic Cleaning Req 7 DC Control (1) 8 DC Control (2) * Emulation Mode for the AITe130V-UL drive returns the following as the Product Identification field of the Inquiry command. SDX-520C * Emulation Mode for the AITe90V-UL drive returns the following as the Product Identification field of the Inquiry command. SDX-420C Data Compression Control DIP switch Data compression can be selected by DIP switches. Data compression is enabled while position 7 [DC Control (1)] is ON. Control by host can be disabled when position 8 [DC Control (2)] is ON. 18 Chapter 2 Preparation