Sony CAV-CVS12ES Installation Manual - Page 7

Rear panel of the Component Video Switcher Getting Started SOURCE 1 IN OUT Y SOURCE 2 IN OUT SOURCE 3 IN OUT SOURCE 4 IN OUT SOURCE 5 IN OUT SOURCE 6 IN OUT SOURCE 7 IN OUT SOURCE 8 IN OUT PB SOURCE 9 SOURCE 10 SOURCE 11 SOURCE 12 IN OUT ASSIGNABLE IN OUT ASSIGNABLE IN OUT ASSIGNABLE IN OUT ASSIGNABLE PR S9 S10 S11 S12 IR REMOTE RS-232C VIDEO OUT VIDEO OUT VIDEO OUT VIDEO OUT VIDEO OUT VIDEO OUT VIDEO OUT VIDEO OUT VIDEO OUT VIDEO OUT VIDEO OUT VIDEO OUT IN AUX CAV ZONE 1 ZONE 2 ZONE 3 ZONE 4 ZONE 5 ZONE 6 ZONE 7 ZONE 8 ZONE 9 ZONE 10 ZONE 11 ZONE 12 ~ AC IN  SOURCE 1 ~ 8 connection jacks a) VIDEO IN An RCA jack for component video input from a source component. b) VIDEO OUT An RCA jack for connecting a video source to another local component. Note The video loop-through output is not active when the Main Unit is turned off.  SOURCE 9 ~ 12 connection jacks a) VIDEO IN An RCA jack for composite video input from a source component. b) VIDEO OUT An RCA jack for connecting a video source to another local component. The composite video signal is up-converted to the component video signal automatically. Note The video loop-through output is not active when the Main Unit is turned off.  ASSIGNABLE switch for SOURCE 9 ~ 12 Assign the source component connected to source 9 ~ 12 to source 1 ~ 8. For example, when the SOURCE 9 ASSIGNABLE switch is set to "1", the source 9 video signal is distributed to the zone selected for source 1. Notes  Set the ASSIGNABLE switch to "0" when you do not use the assign function.  When you assign two or more source components to the same source number, the assigned source numbers of SOURCE indicator blink as an error indication.  AC IN Connects the supplied AC power cord to AC IN.  ZONE VIDEO OUT A CAT5 RJ45 connector that sends a source video signal to the component video input of a zone. Use a CAT5 cable for the connection.  IR REMOTE IN A 3.5 mm monaural mini jack for receiving the SIRCS code from the connected IR-controlled component. The Main Unit can be equally controlled by the RS-232C commands. Note The remote control is not supplied.  RS-232C a) AUX Connects to other RS-232C components, allowing the Main Unit to be controlled by other RS-232C components. Use an RS-232C cross cable for the connection. b) CAV Connects to the CAV-M1000ES, allowing the Main Unit to be controlled by the CAV-M1000ES. Use an RS-232C cross cable for the connection. US