Sony CDX-L600X Operating Instructions - Page 15

Adjusting the sound, characteristics, Quickly attenuating the, sound

Page 15 highlights

Changing the operative direction The operative direction of controls is factoryset as shown below. To increase To decrease If you need to mount the rotary commander on the right hand side of the steering column, you can reverse the operative direction. Press (SOUND) for 2 seconds while pushing the VOL control. Adjusting the sound characteristics You can adjust the bass, treble, balance, and fader. The bass and treble levels can be stored independently for each source. 1 Select the item you want to adjust by pressing (SOUND) repeatedly. Each time you press (SOUND), the item changes as follows: BAS (bass) t TRE (treble) t BAL (left-right) t FAD (front-rear) 2 Adjust the selected item by pressing either side of (SEEK). When adjusting with the rotary commander, press (SOUND) and rotate the VOL control. Note Adjust within 3 seconds after selecting the item. Quickly attenuating the sound (With the rotary commander or the card remote commander) Press (ATT) on the rotary commander or card remote commander. After "ATT-ON" momentarily appears, the "ATT" appears in the display. To restore the previous volume level, press (ATT) again. 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44

15
Changing the operative direction
The operative direction of controls is factory-
set as shown below.
If you need to mount the rotary commander on
the right hand side of the steering column, you
can reverse the operative direction.
Press
(SOUND)
for 2 seconds while
pushing the VOL control.
To increase
To decrease
Adjusting the sound
characteristics
You can adjust the bass, treble, balance, and
fader.
The bass and treble levels can be stored
independently for each source.
1
Select the item you want to adjust by
pressing
(SOUND)
repeatedly.
Each time you press
(SOUND)
, the item
changes as follows:
BAS (bass)
t
TRE (treble)
t
BAL (left-right)
t
FAD (front-rear)
2
Adjust the selected item by pressing
either side of
(SEEK)
.
When adjusting with the rotary
commander, press
(SOUND)
and rotate the
VOL control.
Note
Adjust within 3 seconds after selecting the item.
Quickly attenuating the
sound
(With the rotary commander or the card
remote commander)
Press
(ATT)
on the rotary commander or
card remote commander.
After
ATT-ON
momentarily appears, the
ATT
appears in the display.
To restore the previous volume level, press
(ATT)
again.